...

Licensed in Oklahoma (#OK150297) & Arkansas (#AR0006563)

serving Stilwell and nearby communities with reliable HVAC care.

Heat Pump Not Heating? Common Causes and Proven Fixes

Heat pump not heating? Learn the common causes, from thermostat settings to defrost and refrigerant issues, plus safe checks before you call Girdner today.
Girdner Heat and Air team
Girdner Heat and Air team
TLDR

Table of Contents

Heat pump not heating causes

A heat pump not heating usually has one of five problems: a wrong thermostat setting, a clogged air filter, a frozen outdoor unit, a tripped breaker, or low refrigerant. The first four you can often check yourself in 15 minutes. If those look fine, our heat pump service team can find the real cause fast.

Key Takeaways

  • Lukewarm air can be normal. Heat pump air often feels cooler than furnace air, even when the system works fine.
  • Check the easy stuff first. Thermostat mode, filter, breakers and the outdoor unit cause most no-heat calls.
  • Frost is normal, thick ice is not. A light frost melts in a defrost cycle. A solid block of ice needs a technician.
  • Refrigerant and electrical parts need a pro. Leaks, capacitors, contactors and reversing valves are not DIY jobs.
  • Maintenance prevents most failures. A clean filter and a yearly tune-up stop many winter breakdowns before they start.

Is Your Heat Pump Actually Broken, or Is It Working Normally?

Before you assume the worst, it helps to know what normal heat pump heat feels like. A heat pump does not burn fuel. It moves heat from the outdoor air into your home. Because of that, the air at your vents is usually around 90 to 100 degrees, not the 120 degree blast a gas furnace gives you.

Put your hand in front of a vent and it can feel cool, since your skin is about 93 degrees. That does not mean the system failed. The real test is whether your home reaches and holds the temperature on the thermostat.

Three Normal Behaviors That Look Like Problems

  • Defrost mode. In cold, damp weather, the outdoor coil collects frost. The system switches into defrost for a few minutes, the outdoor fan stops, and you may see steam. Indoor air may feel cooler during this time.
  • Long run times. On a 25 degree night in eastern Oklahoma, a heat pump may run almost nonstop. That is how it is designed to keep up.
  • Auxiliary heat turning on. When the heat pump cannot keep up alone, backup electric heat strips help. Your thermostat may show “Aux Heat.” That is normal in a cold snap.

The Department of Energy explains that a properly installed heat pump can deliver up to three times more heat energy than the electricity it uses. That efficiency is why the air feels gentler. It is not a sign of failure.

Technician running a diagnostic on a heat pump not heating in Oklahoma

What Causes a Heat Pump Not Heating? Diagnose It by Symptom

The fastest way to narrow down the cause is to match what you see with the most likely problem. Use this table before you touch anything.

What You NoticeMost Likely CauseDIY Check or Pro Job?
Cold air from vents, outdoor unit not runningTripped breaker, failed capacitor or contactorCheck breaker yourself. Electrical parts need a pro
Lukewarm air, home never reaches set temperatureDirty filter, low refrigerant, or undersized systemChange filter yourself. Refrigerant is a pro job
Outdoor unit covered in thick iceFailed defrost board, sensor, or low refrigerantPro job
Cold air blowing in heat mode, outdoor unit runningStuck reversing valve or wrong thermostat modeCheck thermostat yourself. Valve is a pro job
Nothing runs at all, blank thermostatDead thermostat batteries, tripped breaker, blown fuseDIY check first
Heat works, but bills spiked and Aux Heat stays onHeat pump failed, backup strips doing all the workPro job

Thermostat Settings

The thermostat is the most common cause and the easiest fix. Make sure it is set to Heat, not Cool or Off. Set the fan to Auto, not On. When the fan is set to On, it blows air even when the system is not heating, and that air feels cold. Also check the batteries if the screen is dim or blank.

Dirty Air Filter

A clogged filter chokes airflow across the indoor coil. The heat pump then overheats, trips a safety limit, and shuts down. The Department of Energy notes that a system needs about 400 to 500 cubic feet of air per minute for each ton of capacity, and performance drops sharply when airflow falls well below that.

Frozen Outdoor Unit

Light frost is normal. A thick shell of ice that will not melt is not. That usually means the defrost control board, the defrost sensor, or low refrigerant is the real problem. Never chip ice off the coil with a tool. The fins bend easily and the refrigerant lines can puncture.

Low Refrigerant

A heat pump runs on a sealed refrigerant loop. It should never “run low” unless there is a leak. Signs include hissing sounds, ice on the copper lines, and weak heat on mild days. Only a licensed technician can find the leak, fix it, and recharge the system.

Failed Electrical Parts

The capacitor gives the motors a kick to start. The contactor is a switch that sends power to the outdoor unit. When either fails, the outdoor unit hums or stays silent while the indoor fan keeps blowing. These parts carry high voltage, so they stay a pro job.

Stuck Reversing Valve

The reversing valve switches your heat pump between heating and cooling. If it sticks in cooling mode, you get cold air in winter even though everything runs. A technician can test the valve coil and the thermostat wiring that controls it.

Technician servicing an outdoor heat pump unit that is not heating

How to Troubleshoot a Heat Pump That Won’t Heat: 7 Safe Steps

These steps are safe for any homeowner. Work through them in order. If the heat is still out after step 7, stop and call a technician.

  1. Check the thermostat. Set it to Heat, set the fan to Auto, and raise the temperature 3 degrees above the room temperature. Replace the batteries if the display looks weak.
  2. Check the air filter. Pull it out and hold it up to a light. If you cannot see light through it, replace it.
  3. Check the breakers. Your heat pump has two breakers: one for the indoor air handler and one for the outdoor unit. If one tripped, turn it fully off, then on, one time only.
  4. Check the outdoor disconnect. Look for a small gray box on the wall near the outdoor unit. Make sure the switch or pull-out block is fully in place.
  5. Clear the outdoor unit. Remove leaves, snow, and debris. Keep about two feet of open space around all sides.
  6. Wait out a defrost cycle. If you see light frost and steam, give it 15 to 20 minutes. Normal heat should return.
  7. Open the supply vents. Closed or blocked vents restrict airflow and make the system work harder. Open them and move furniture away.

Do not reset a breaker more than once. A breaker that trips again is warning you about an electrical fault. Call (918) 380-0760 instead.

How Much Does It Cost to Repair a Heat Pump That Is Not Heating?

Repair cost depends on which part failed. Small electrical parts are the most common and the least expensive fixes. Refrigerant leaks and major components cost more. Here are typical national price ranges homeowners see, before local factors like brand, access and warranty status.

RepairTypical RangeNotes
Capacitor replacement$150 to $400One of the most common no-heat repairs
Contactor replacement$150 to $450Often worn by insects or pitting
Defrost board or sensor$200 to $600Fixes a unit that keeps icing over
Refrigerant leak repair and recharge$300 to $1,500+Depends on leak location and refrigerant type
Reversing valve replacement$800 to $2,000Labor heavy, requires refrigerant recovery
Compressor replacement$1,800 to $4,000+On older units, replacement may make more sense

Girdner Heat and Air gives upfront pricing before any work starts, and we offer free second opinions. If a big repair is on the table, we will show you the repair cost next to a replacement option so you can decide what fits your budget.

Girdner technician testing an outdoor heat pump coil in Oklahoma

When Should You Call a Professional for a Heat Pump Not Heating?

Call a licensed technician when the simple checks do not bring the heat back, or right away if you notice any warning sign below. Waiting can turn a $200 part into a $2,000 repair.

Signs You Need Expert Help

  • A breaker trips again after one reset
  • Thick ice covers the outdoor coil for more than a few hours
  • You hear buzzing, grinding, or loud clicking from the outdoor unit
  • You smell burning plastic or electrical odors
  • Your thermostat shows Aux or Emergency Heat all day, every day
  • Your electric bill jumped with no change in weather
  • The system is over 12 years old and needs repairs often

What a Technician Checks

During a full system diagnostic visit, a technician tests capacitor and contactor readings, measures refrigerant pressures and temperatures, checks the defrost board and sensor, tests the reversing valve, and confirms airflow across the coil. You get a plain-language explanation of what failed and your options.

Our team in Stilwell is available 24/7 for no-heat calls across eastern Oklahoma and western Arkansas. Call (918) 380-0760 and we will walk you through it on the phone first.

Should You Use Emergency Heat When Your Heat Pump Stops Heating?

Emergency heat is a manual setting that shuts off the heat pump and runs only the backup electric strips. It keeps your home warm when the outdoor unit has failed, such as after ice storm damage or a frozen coil that will not thaw.

Use it only as a short-term bridge until a technician arrives. Backup strips heat like a giant toaster, so they cost far more to run than the heat pump. Once the repair is done, switch the thermostat back to normal Heat mode.

If your heat pump keeps relying on backup heat, the system may be undersized or worn out. In that case, it is worth comparing options. Our guide on heat pump versus furnace explains which works best for Oklahoma winters.

HVAC technician using a meter to diagnose a heat pump not heating

How to Prevent Your Heat Pump From Failing This Winter

Most no-heat calls in December and January trace back to small issues that a tune-up would have caught in the fall. A little prevention keeps your system running through the coldest nights.

  • Change the filter every 1 to 3 months. Change it monthly if you have pets or run the system nonstop.
  • Keep the outdoor unit clear. Rake leaves, trim shrubs, and keep snow off the top.
  • Schedule a fall tune-up. A technician cleans coils, tests electrical parts, checks refrigerant, and confirms the defrost cycle works.
  • Use moderate thermostat setbacks. The Department of Energy advises that deep setbacks can make a heat pump run inefficiently and trigger costly backup heat.
  • Watch your bills. A sudden jump often means the heat pump is struggling before it fully fails.

A yearly HVAC maintenance plan covers tune-ups, priority service, and lower repair costs, so you are not stuck waiting during a cold snap.

Frequently Asked Questions

How do I reset my heat pump?

Turn the thermostat off. Switch off both heat pump breakers at your electrical panel and wait 5 minutes. Turn the breakers back on, wait another 5 minutes, then set the thermostat to Heat. Some units also have a reset button on the outdoor unit. If it fails again, call a technician.

Why is my heat pump blowing cold air in heat mode?

The most common causes are the fan set to On instead of Auto, a defrost cycle in progress, low refrigerant, or a stuck reversing valve. Check the thermostat and wait 20 minutes for defrost to finish. If cold air continues, a technician should test the valve and refrigerant.

Does a heat pump work below freezing in Oklahoma?

Yes. Modern heat pumps keep heating well below 32 degrees, though output drops as temperatures fall. During the coldest nights, backup heat strips help. Cold-climate models handle extreme cold even better. A properly sized system keeps most Stilwell homes comfortable all winter.

How long do heat pumps last?

Most heat pumps last 10 to 15 years with regular maintenance. Because they run in both summer and winter, they see more hours than a furnace or AC alone. Yearly tune-ups and regular filter changes help you reach the top of that range.

Get Your Heat Back With a Local Stilwell Technician

If your heat pump is not heating after the simple checks, call Girdner Heat and Air at (918) 380-0760 and tell us what you see at the outdoor unit and the vents. A licensed technician will diagnose the problem, explain it in plain language, and give you upfront pricing before any work starts.

We are available 24/7 for no-heat calls in Stilwell, Tahlequah, Sallisaw, Westville, Fort Smith, Van Buren and nearby towns in Oklahoma and Arkansas. You can also request service online.

Author Info

Alex Girdner

Owner & Lead HVAC Technician | Girdner Heat and Air LLC

Alex Girdner is the owner of Girdner Heat and Air LLC, a licensed HVAC contractor based in Stilwell, Oklahoma. With 15 years of local HVAC experience and a strong reputation for upfront pricing and five-star service, Alex helps homeowners stay comfortable with expert AC repair, furnace repair, system diagnostics, indoor air quality solutions, and residential HVAC installations. He serves Stilwell and surrounding areas including Tahlequah, Sallisaw, Muskogee, Fort Gibson, and nearby communities in Arkansas such as Siloam Springs, Fort Smith, and Van Buren. Alex and his team are known for clear communication, “on-my-way” updates, clean workmanship, and dependable solutions built to last.

Why Homeowners Trust Us

WE’RE ON THE WAY. CALL NOW.